ClimateRight CR-2550 Uživatelský manuál stáhnout pdf (Strana 71)

3-2

CHAPTER 3

Engine Alignment

The engine uses a rubber splined hub to which the outdrive drive shaft

is attached. This alignment speciﬁ cation between the engine and out

drive needs to checked periodically. It should be checked after each 50

hours of operation or if the vessel has run aground or hit a submerged

object. Alignment should be checked by a Regal dealer or marine

professional since special tools and procedures are required.

Engine Removal

In the event the engine or outdrive (sometimes referred to as stern

drive) requires major service where it needs to be removed, consult

your Regal dealer.

Engine Ventilation

Ventilation systems are required for engine compartments. Your boat

features a set of deck vent shrouds with mesh covers which supply fresh

air constantly to the engine compartment. A powered blower motor

connected to ducts in the lower one third of the bilge evacuates air to

the atmosphere. Pay close attention to the following warning.

WARNING

GASOLINE VAPORS CAN EXPLODE. BEFORE STARTING

ENGINE, OPERATE BLOWER 4 MINUTES AND CHECK

ENGINE COMPARTMENT FOR GASOLINE LEAKS OR

VAPORS. RUN BLOWER BELOW CRUSING SPEED.

All owners are responsible for keeping their boat’s ventilation systems in

operating condition. This means making sure the ventilation covers are

obstruction free, ducts are not blocked or tore, blower operates properly

and any worn parts are replaced with approved marine parts.

3-2