ClimateRight CR-2550 Uživatelský manuál Strana 205

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 349
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 204
CHAPTER 6
6-62
If equipped, the pressurized water system needs to be initially lled
to operate properly
.
1. Unscrew the “water ll” deck tting. Fill the fresh water tank with
approximately 10 gallons of fresh water with a suitable container or
hose. Make sure the water is safe for drinking.
2. Find the helm fresh water pump switch and energize to the “on”
position. Pressurized water tank will ll entire system with fresh
water.
3. Open the faucet to allow any air to escape. Close the faucet when
there is a steady stream of water without air. You will hear the
pressure switch shut off the pump indicating the system is full.
4. If equipped with a cold water transom shower and/or bow
washdown repeat step #3.
5. After these initial procedures, “top” the system off with fresh
water.
6. Check for system leaks as evidenced by the pressure water pump
recycling even though no water is being used from the faucet.
7. It is a good idea to turn “off ” the fresh water pump switch after
each use.
CAUTION
!
AVOID PRESSURE PUMP BURN OUT!
DO NOT ACTIVATE THE FRESH WATER
SYSTEM WITH THE WATER TANK EMPTY.
CHAPTER 6
6-62
If equipped, the pressurized water system needs to be initially lled
to operate properly
.
1. Unscrew the “water ll” deck tting. Fill the fresh water tank with
approximately 10 gallons of fresh water with a suitable container or
hose. Make sure the water is safe for drinking.
2. Find the helm fresh water pump switch and energize to the “on”
position. Pressurized water tank will ll entire system with fresh
water.
3. Open the faucet to allow any air to escape. Close the faucet when
there is a steady stream of water without air. You will hear the
pressure switch shut off the pump indicating the system is full.
4. If equipped with a cold water transom shower and/or bow
washdown repeat step #3.
5. After these initial procedures, “top” the system off with fresh
water.
6. Check for system leaks as evidenced by the pressure water pump
recycling even though no water is being used from the faucet.
7. It is a good idea to turn “off ” the fresh water pump switch after
each use.
CAUTION
!
AVOID PRESSURE PUMP BURN OUT!
DO NOT ACTIVATE THE FRESH WATER
SYSTEM WITH THE WATER TANK EMPTY.
Zobrazit stránku 204
1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 348 349

Komentáře k této Příručce

Žádné komentáře